Etaluma LS460 Посібник із запуску - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник із запуску для Мікроскоп Etaluma LS460. Etaluma LS460 14 сторінок. Lumascopes with lumaview (for use with ls560, ls460, ls600, ls620, ls720)

Друкувати сторінку

1. Launch the Lumaview software from the desktop icon (or other chosen location) and allow the LS560 to

be discovered. This may take a minute or so the first time. Two windows will open on your monitor:

a. Live Image Window inside the larger Main Window. "Live Image Window" will be in the title bar

when the Window is not maximized. When Live Image Window is maximized, [Live Image Window]

transfers to the end of the Main Window title bar.

The Live Image Window status bar at the bottom shows communication with the sensor via

continuous display of several useful metrics: current frame rate, data transfer rate, number of

frames collected thus far in the session, frame size, and session date and time start.

b. Main Window with Lumaview v(version number) in the title bar. When the Live Image Window is

maximized, the title bar becomes Lumaview v(version number) – [Live Image Window].

2. The Live Image Window includes a Left Toolbar with the following commands:

a. Manual Image

b. Snap Image

c. Video Record

d. Protocol

e. Zoom

Last File

3. The icon that appears in your computer dock corresponds to a document with an arrow.

C. Instrument Setup

1. Click on Configuration in the File Menu bar to open the drop-down

menu and select Instrument Setup to open its dialog box.

2. Check the Lumaview version to make sure it is the most recently

posted version on the Etaluma website

(www.etaluma.com/products/downloads/). Ensure LS560 (or

LS460) is checked. If it is necessary to change the LS Microscope

model number, you will be prompted to restart the program. Be

sure to restart so that all functionalities work correctly.

3. Click the Objective button to open its dialog box (called

Objective Lens Selection). Select the desired objective to

highlight it. Note that the other blanks about the objective and

image automatically fill based on magnification and a frame size

of 1200 x 1200 pixels. Click OK. Once selected, the same

information automatically fills in Instrument Setup.

4. Click the Frame Size button to open its dialog box. Using the pull-down menu, select frame size (frame

size will be the number times itself because it is square). Default is 1200 x 1200 pixels. Maximum is

2017.11.20

LS560/460 Startup Guide