ASG EasyLine 4G Посібник з встановлення та експлуатації - Сторінка 11
Переглянути онлайн або завантажити pdf Посібник з встановлення та експлуатації для Блок управління ASG EasyLine 4G. ASG EasyLine 4G 16 сторінок. Miniature phone line (pstn) simulator
Друкувати сторінку
GSM signal reading
You can display the graph shown in the picture about the state of the GSM signal strength.
•
You can display the GSM field strength with the button Maintenance → Display GSM signal.
•
You can read the values by pressing the read button.
•
The change in field strength is displayed in hourly resolution. The elapsed time must be read backwards
accordingly
•
The diagram is divided from 0 to 31 on the vertical scale, the value 31 means the best field strength.
•
The figure can be enlarged as desired with the left mouse button.
Basic datas
You can enter more important information about the installed GSM module. In addition to the customer's name
and installation address, you can also specify the phone number of the SIM card inserted in the module and
the type of the connected alarm center.
•
The entered data is stored on the module
•
Completing it can be useful in case of maintenance performed later.
Add phone numbers for notification
In the phone numbers menu, you can enter the numbers to which you want to send SMS and/or voice
messages. The numbers entered here must be in international format for reliable operation.
(Pl.:+36301234567 vagy 0036301234567)
•
You can enter a maximum of 8 phone numbers to be notified.
•
You can select these numbers in other parts of the program.
•
You can also edit the list here via SMS with the command "TELx=Telephone number", where "x" denotes
the serial number of the phone number you want to edit.
•
(Example: 1234TEL1=+36301234567, 1234TEL2=+36304564323)
•
More under SMS commands
Add control phone numbers
•
In the Control phone numbers window, you can specify which numbers can control your outputs.
•
Phone numbers can be stored in the module's internal memory (up to 1000), and you can save additional
numbers on the SIM card inserted in the module. Phone numbers on the SIM card can only be read with
ProRead.
•
If internal memory is used, the module will be independent of the memory content of the inserted SIM
card.
•
Before editing the list, always read the contents of the memory using the Read numbers from memory
button. To save, use the Write numbers to memory button and then the send button.
•
Entered phone numbers must be in international format. Here, due to the length of the number, +36 is
recommended (e.g.: +36301234567).
•
It is also possible to save, edit and open stored numbers (from a .csv file).
•
You can also assign phone numbers to specific outputs.
•
You can also modify the list using an SMS command using the commands ADD=Phone number (add) and
DEL=Phone number (delete). (Példa: 1234ADD=+36301234567, 1234DEL=+36301234567)
EasyLine 4G
www.ascglobal.eu
11