Akron 3462 Інструкція з експлуатації - Сторінка 6
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Вимірювальні прилади Akron 3462. Akron 3462 17 сторінок. Forestry bumper monitor
Також для Akron 3462: Інструкції з монтажу, експлуатації та обслуговування (18 сторінок)
Друкувати сторінкуINSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS
5.
Remove gearbox housing (19) from the motor assembly (15).
6.
Replace o-ring seal (18) on the gearbox housing (19).
7.
Attach the new motor assembly (15) to the gearbox housing (19) making sure all four screws (21) are tight.
8.
Install the motor and the gearbox housing assembly to the unit making sure all four socket screws (49) are tight. It
may be necessary to rotate the motor slightly to get the motor gear to line up with the gears inside the gearbox.
9.
Restore power to the unit.
10. Test the operation of the unit.
Call Akron Brass Customer Service Department if any problems are encountered.
TABLE 1
Symptom
Potential Cause
Totally Inoperative
Lack of Power
Damaged Control Box
No CAN Communication
PHONE: 800.228.1161 | WEBSITE: www.akronbrass.com
Sheet: 122386
STYLE 3462 FORESTRY BUMPER MONITOR
What to Check
Remove the Power/Valve Cable connector from
the control box mounted on the side of the
monitor/turret. Check for voltage approximately
equal to vehicle battery voltage between pins 1
(Pos.) and 2 (Neg.) of the cable's connector.
Remove the CAN Cable connector from the
control box mounted on the side of the
monitor/turret. Check for voltage approximately
equal to vehicle battery voltage between pins 1
(Pos.) and 2 (Neg.) of the control box connector.
Insert an empty USB Flash Drive (with a status
LED) into the USB connector. Check for lighting of
the Flash Drive status LED.
Check status LED's located near the Joystick
connector for power and CAN activity.
Revision 12/2022
Solution
If no measurable voltage is present, insure proper
DC power is applied to pins 1 and 2.
If no measurable voltage is present, return the
Control Box/Harness for replacement.
If the Flash Drive status LED does not light, return
the Control Box/Harness for replacement.
If no status LED's are lit, check CAN cable continuity
end to end (1 to 1, 2 to 2, etc.), and retest.
If only Power status LED is lit, return the Joystick for
replacement.
If only Power and Transmit LED's are lit, return the
Control Box/Harness for replacement.
Page: 6 of 17