Dolby Laboratories CP750 Посібник з монтажу - Сторінка 12
Переглянути онлайн або завантажити pdf Посібник з монтажу для Комп'ютерне обладнання Dolby Laboratories CP750. Dolby Laboratories CP750 19 сторінок. 7.1 audio for the dolby multichannel amplifier
Друкувати сторінку
- 1. Introduction to Dolby Cp750 7.1 Audio for the Dolby Multichannel Amplifier
- 2. About the Cp750 (or Other Cinema Processor) Configuration for the
- 3. Connecting a Cp750 (or Other Sound Processor) to a Media Block
- 4. Configuring Advanced Connections
- 5. Cp750 Audio Output Cable Pinouts
- 6. To 25-Pin D-Connector Digital Audio Pinouts
6. After rebooting, reconnect with the Yamaha device, then click the Transmit tab in the Device
View window, and click the Create a New Multicast Flow button.
7. In the Create Multicast Flow pop-up screen, click (to check) in the AES67 Flow box, then
select the first eight channels, and click the Create button.
A multicast flow is now listed in the Transmit Flows pane of the Transmit window. This
specifies that audio received on analog channel 1 from the cinema sound processor is routed
out of digital channel 1 of the Yamaha device, channel 2 is routed out of digital channel 2, and
so on. You have now completed the AES67 setup in the Dante Controller software.
8. Connect the Yamaha Tio1608-D Primary Ethernet port directly to the amplifier DOLBY
ATMOS CONNECT IN port.
Dolby CP750 7.1 audio for the Dolby Multichannel Amplifier Installation Manual
7 May 2018 Issue 1
Setting up the system
12