Cypress CY8CKIT-002 Посібник з експлуатації комплекту - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник з експлуатації комплекту для Материнська плата Cypress CY8CKIT-002. Cypress CY8CKIT-002 16 сторінок. Psoc miniprog3 program and debug kit guide

Друкувати сторінку

Installing MiniProg3

This chapter shows how to install MiniProg3 and its associated PC software.

2.1

MiniProg3

Figure 2-1. Top View

USB MiniProg3

Connector

Figure 2-2. Bottom View

2.2

MiniProg3 Installation

The MiniProg3 programmer/debugger is supported by PSoC Programmer, PSoC Designer, and

PSoC Creator. Secondary software, such as Bridge Control Panel and Clock Programmer, use the

programmer COM hardware layer to support MiniProg3 functionality.

1. Download and install

2. Connect the MiniProg3 to your computer's USB port using the USB cable. When properly

connected, the four LEDs on the MiniProg3 flicker.

The first MiniProg3 driver is automatically installed.

Note: Remove the warning sticker before using MiniProg3.

3. Run PSoC Programmer: Select Start > All Programs > Cypress > PSoC Programmer

<version> > PSoC Programmer <version>.

When PSoC Programmer opens, the second MiniProg3 driver is automatically installed.

CY8CKIT-002 PSoC® MiniProg3 Program and Debug Kit Guide, Doc. # 001-59350 Rev. *I

Busy LED

Status LED

PSoC

Programmer. Follow the on-screen instructions to install the software.

10-pin JTAG/SWD

Target Power LED

Connector

Aux LED

5-pin ISSP/I2C/SWD

Connector