Ashly ne4400 Посібник з експлуатації - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Комп'ютерне обладнання Ashly ne4400. Ashly ne4400 20 сторінок. Network enabled dsp processor
Також для Ashly ne4400: Технічні характеристики (3 сторінок), Посібник з експлуатації (20 сторінок), Посібник (20 сторінок)

Друкувати сторінку

Operating Manual - ne8800, ne4800, ne4400

(10.1 WR-5 continued)

Programming of each WR-5 button is done from NE software when the WR-5 is wired to its host NE processor through the

remote data connector, and the processor is connected to a PC via Ethernet. Each WR-5 has its own identifying property and is thus

uniquely represented with its own software control surface, within which the button actions are programmed. Click the <Identify

Remote> button to find a physical WR-5. As mentioned, the Ashly RPS-18 power supply must be used to provide power for any

WR-5 units beyond four in series. Additionally, a provided jumper must be placed on the last and only the last WR-5 in a series, and

even if there is only one WR-5 used (see drawing).

10.2 RD-8C or RW-8C Remote Control (Remote Data)

A second microprocessor based desktop controller, the

Ashly RD-8C (or RW-8C wall mount), is an eight channel

level controller that uses slide faders for individual channel and

master level control and mute. The RD-8C is wired to the four

pin Data Input euroblock connector on the back panel. Only

one RD-8C can be wired to a NE processor. NOTE: When an

RD-8C is used, no other data port based remotes can be used.

In the software DSP control section, a remote gain func-

tion can be placed in any input or output and mapped to any of

the slide faders on an RD-8C for remote level control of that

channel. The RD-8C uses an XLR jack, while the RW-8C uses

a euroblock connector to wire to the NE processor (see wiring

diagram).

10.3 WR-1 Remote Level Control (5VDC)

Individual input or output channels can have remote level

control using a potentiometer assembly such as the Ashly WR-1

and four conductor wire. The WR-1 is a dual potentiometer

remote volume control designed to fit in a standard electrical

wall box. Each volume control is connected to a terminal block

on the WR-1 circuit board, which in turn must be wired to the

processor back panel euroblock connector labeled "5VDC

Remote Control" as shown. Do not connect the WR-1 remote

level control ground to any other external grounds.

Ashly RW-8C Remote Level Controller

Ashly WR-1 Remote DC Level Controller