Cypress Semiconductor CYALKIT-E03 Посібник з експлуатації комплекту - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник з експлуатації комплекту для Аксесуари Cypress Semiconductor CYALKIT-E03. Cypress Semiconductor CYALKIT-E03 19 сторінок. Solar-powered bluetooth low energy sensor beacon 5 pack
Також для Cypress Semiconductor CYALKIT-E03: Посібник із швидкого старту (2 сторінок)

Друкувати сторінку

2. Getting Started

In this chapter,

you will become familiar with the Solar-Powered BLE Sensor Beacon 5 Pack by successfully establishing a

BLE sensor beacon connection

device with apps. This will also confirm that the Solar BLE Sensor and your mobile device are operating properly.

2.1 WSN Operation with PC

In this section, you will confirm that the Solar BLE Sensors is operating as a WSN by using the software provided on your

mobile device to detect temperature and humidity changes.

2.1.1 Establishing BLE Connection

Set the slide switch (SW1) on the five Solar BLE Sensors to Demo mode (DM). The mode is set to Demo Mode from

the factory setting. Refer to

Demo Mode

(DM)

Note: Use the sharp end of something like tweezers (not included in the kit) to change the mode.

Each Solar BLE Sensors are numbered with the IDs (#2 to #6) on the bottom side of the enclosure from the factory.

Refer to

CYALKIT-E02 Kit Guide

CYALKIT-E03 Solar-Powered BLE Sensor Beacon 5 Pack Kit Guide, Document Number. 002-12543 Rev. *B

between

the Solar BLE Sensor operating as a wireless sensor network (WSN), a mobile

CYALKIT-E02 Kit Guide

for detailed information on each mode.

Timer Mode

(TM)

SW1

for information on how to change the ID.