Cytech Comfort DM02 Посібник - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник для Обладнання для запису Cytech Comfort DM02. Cytech Comfort DM02 16 сторінок. Door station interface

Друкувати сторінку

Comfort DM02 Door Station Interface

J2 - Tone: Shunt for louder Beep tone volume. This affects

specific Door station beeps like the beeping tone caused by lack of

communications. Default Open (soft).

J5 – Shunt J5 if the DM02 is to be connected to Comfort's DP04.

This will enable the LED indicator on the DP04 to be turned on

when the MIC is active.

SW1 – Set of 3 shunts to set the ID (see "Door Station ID

Switch").

LED Indicators

D8 – Turns on when the microphone circuit is enabled; i.e. the

outdoor intercom is in talk mode.

Trimmers

VR1 – MIC: Used to tune the microphone gain level from the

outdoor door station to Comfort.

VR2 - VOICE: Used to tune the speaker gain level from Comfort to

the outdoor door station.

Switch

SW2 – Doorbell: Simulates a press of the doorbell for testing.

Door Station ID Switch

Comfort is able to support up to 3 door stations. SW1 is a set of 3

headers which is used to determine the ID, in accordance to the following

table:

In the Comfigurator software, the number of door station must be set to

equal the maximum (ID) number of door station in the system. Do not

set door stations with the same IDs as this clash of IDs will result in

communication failure.

After changing the ID of the door station, remember to reset the DM02

by unplugging and plugging the 12V/COM terminal block.

After setting the IDs of the door stations in the system, the total number

of door stations must be set in the system.

To do this, set the number of door stations in Comfigurator to the correct

number. This can be found under "Configuration"->"Modules and

Settings"->"Number of Door Stations".

SW1-A

Short

Open

Short

SW1-B

Short

Open

SW1-C

Short