Ambient Technologies RCSTEBA Посібник з монтажу та експлуатації - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Пульт дистанційного керування Ambient Technologies RCSTEBA. Ambient Technologies RCSTEBA 11 сторінок. Thermostatic on/off and blower remote control– 120vac

Друкувати сторінку

to the OFF position. Make sure the receiver privacy (DIP) switches are set the same. Follow the

instructions on how to set the privacy (DIP) switch setting.

By disabling this feature, your appliance may continue to run unattended.

Optional Wall Cover Plate:

1. Receiver snaps into wall cover plate. The wall plate is mounted by using 2 screws provided.

Light your gas appliance following the appliance lighting instructions that came with the appliance.

Confirm that the pilot light is on; it must be in operation for the remote control to operate the main gas

valve and blower. Appliance control knob must be in the ON position, and appliance ON/OFF switch must

be in OFF position.

Slide the 3 position button on the remote receiver to the ON position and the main gas flame should ignite.

Slide the button to OFF and the main gas flame should extinguish, but the pilot light will remain on.

Slide the button to RS (the center position), then press the ON button on transmitter to turn the system ON.

The main gas flame should ignite and blower should come on after the On Delay Time is reached and fan

speed you desire is selected.

Press the OFF button on transmitter to turn the system to OFF. The flame should extinguish (the pilot light

will remain on) and blower should be off after the Off Delay Time you set.

Symptom

1. Battery icon on

LCD on transmitter.

2. LCD display is

blank

3. LCD display shows

"funny" display

4. Appliance does not

come on.

5. Receiver cannot

receive signal.

6. Blower is not on

after the fireplace is

turned on

50D0112

RCSTEBA Installation & Operating Manual

Rel 1.0 April 2009

TESTING YOUR NEW REMOTE CONTROL SYSTEM

TROUBLESHOOTING

Causes

1. Low Battery

1. Wiring / Electrical Connections

2. Privacy (DIP) switch setting on transmitter

does not match receiver

3. Transmitter measures temperature exceeding

99 degrees Fahrenheit and shows "HI" on LCD

4. Distance between the transmitter and receiver

is more than 30 feet

1. Receiver is installed in an enclosure

1. Blower setting is off

2. Blower delay setting is set too high

1. Replace batteries. Change

batteries every 6 months.

2. Check battery installation or

replace batteries.

3. Press Reset button at the back of

the transmitter.

1. Slide the switch to ON, if

appliance comes ON, wiring is

not the cause.

2. If appliance does not come on,

check wiring connections.

1. Make sure the transmitter and

receiver have the same DIP

switch settings.

1. Move transmitter to a cooler

place and wait until temperature

drops below 99 degree.

1. Make sure the operating distance

is less than 30 feet

1. Make sure the receiver is not

located inside to tight of an

enclosure.

1. Press FAN key to select Fan

speed you desire.

2. Press and hold FAN key to set

Page 10 of 10

Action

Ambient Technologies

A Division Of

Monessen Hearth Systems