DPCAV PANDORA Handbuch - Seite 2

Blättern Sie online oder laden Sie pdf Handbuch für Kontrolleinheit DPCAV PANDORA herunter. DPCAV PANDORA 7 Seiten. Pan & tilt kit

Assembly Tips:

You can build Pandora two ways: As a bottom (under carriage) mount or a top (cockpit view)

mount. The assembly steps for these two versions are nearly the same. Just follow the

instructions to build the version you need.

Pandora's chassis construction uses simple tab and slot construction. Tabs are labeled with

single letters and the mating slots are labeled with a double letter. For example, Tab A goes to

Slot AA and Tab B goes to Slot BB. The identification text is printed on the chassis parts.

For the best fit, the Tab's inside rounded corners should be filed or cut square. This will ensure

that the parts fit close together.

You may use fast curing Epoxy or a soldering iron to build your Pandora chassis. The

soldering method is best suited for experienced builders, but it will reduce the assembly time

considerably. That is because there is no waiting for the adhesive to dry.

Whenever you have any doubt on how something goes together, just review the various

photos. I suspect your questions will be resolved by reviewing the examples that are shown.

Chassis Assembly:

Using the details shown in Figures 1 and 2, gather

the left side panel (item 1), right side panel (item 2)

bottom chassis (item 3), front bulkhead (item 4)

and rear bulkhead (item 6). Dry fit the parts; trim

the inside corners of any tab that does not allow

proper seating in the mating slot.

Note: Be sure to install the panels so that their

circled ID numbers (

inside of the chassis. Please review the photo for

the proper position of each panel.

Once everything fits properly, assemble them with

15-minute epoxy or use your soldering iron (your

choice).

Figure 4,

Solder Fillet

(

), www.dpcav.com

ANDORA

REV-C

, and

) are on the

Note: Soldering the chassis requires a fine fillet bead of solder

along the inside seams. Do not use too much solder! Your fillets

should look smooth and appear as shown in the figure on the left.

Page 2

Figure 3, Main Chassis