Dremel DigiLab 3D45 Dienstanweisungen - Seite 4

Blättern Sie online oder laden Sie pdf Dienstanweisungen für 3D-Drucker Dremel DigiLab 3D45 herunter. Dremel DigiLab 3D45 4 Seiten. Print removal
Auch für Dremel DigiLab 3D45: Schnellstart-Handbuch (2 seiten), Gebrauchsanweisung (2 seiten), Handbuch (4 seiten), Service-Handbuch (4 seiten), Handbuch Kalibrierung (2 seiten), Schnellstart-Handbuch (2 seiten)

iii. Press "test" twice to check the orientation after adjust-

ment in vertical position. If not satisfied with the orienta-

tion of the arm, repeat step i. and ii. until desired

orientation is achieved in vertical position.

iv. Press "test" once to move the arm in the stow position.

v. Ensure the leveling arm is NOT exposed like it is shown

in Figure 13 below.

Figure 13. Exposed leveling arm in stowed position.

vi.If yes, press - to decrease angle in front of "up". Refer

to Figure 12b.

2610038113

Congratulations!

You are now ready to build. Build On.

vii. If the arm makes a hitting sound or rebounds back while

stowing, then it is stowing too high. In that case, press

+ to increase angle of stowing in front of "up". The arm

should be stowed as shown in the Figure 14 below, such

that it doesn't expose or rebound.

Figure 14. Leveling arm in stowed position.

viii. Once the angles are adjusted for both vertical and stow-

ing positions, press "next".

Step 8: Nozzle Gap Calibration

a. Follow Nozzle Calibration instructions.

07/2018