Atlas Copco PN 3500 Reparaturanleitung - Seite 6
Blättern Sie online oder laden Sie pdf Reparaturanleitung für Bohrer Atlas Copco PN 3500 herunter. Atlas Copco PN 3500 18 Seiten.
Seite drucken
1
Dismantling the
Remove the rubber O-ring (6).
back gear shaft
2
Remove the washer (5) and the thrust
bearing (4) as well as the disk (3).
3
Press off the back gear wheel (2).
4
Remove the remaining parts from the
back gear shaft (B):
- tumble drive (1)
- washer (7)
- coupling box (8)
- spring (9) and
- washer (A).
1
Removing the
Remove the locking ring (1) with aid of
angle drive
special pliers.
2
Remove the angle drive (4) together with
the disk (2), the washers (3) as well as the
support ring (5).
If necessary, hit the gear housing lightly
with a plastic hammer for support.
3
4
If this bevel wheel will be used again,
please note the number of the washers.
Mount the same number when re-assem-
bling.
1
Removing the
Loosen the four screws (1) and remove
motor cover
the motor cover (2).
2
Remove the rubber cap (3) in case of
damage.
Attention! The rubber O-ring (6) fits
tightly and is difficult to remove.
Depending on the tolerance of the
bearing the tool can be equipped with
two or three washers (3).
Repair Instructions No.179.11/97
PN 3500 / PN 3500 X
1
2
3
3
2
1
1
2
3
4
5
9
8
7
B
A
4 5
PAGE
5
6
10
11
12