Apogee QUICK DRAW Handbuch - Seite 4
Blättern Sie online oder laden Sie pdf Handbuch für Spielzeug Apogee QUICK DRAW herunter. Apogee QUICK DRAW 12 Seiten.
Seite drucken
Fin Can Assembly
16. Remove the fins from the fin sheet (P/N 15723)
with a sharp hobby knife.
17. Using a sanding block such as the Sanding Tee
(P/N 02100), sand the surface and edges of the fins
to remove any roughness and to prepare for final
finishing.
18. When mounting the fins, ensure that they are
aligned with the aft edge of the body tube, parallel
with the long axis of the body tube, and at right angles
to the body tube and each other. For the easiest
alignment, a fin alignment guide can be used. Glue
the fins in place. Allow them to dry before continuing.
19. Glue the launch lug in place along the launch lug
line at the mark 4" (100 mm) from the forward end of
the tube using wood glue.
20. Apply fillets to the root of the fins and around the
launch lug by applying a bead of wood glue and shap-
ing it with a finger.
Forward Section Assembly
21. The kit includes two sections of Kevlar shock cord.
The longer (8 ft) piece will become the main shock
cord. From the other piece, cut an 8" (200 mm) length
and then cut the remainder in half. This will give you
two 23" (580 mm) lengths. Set the two 23" pieces
aside for use in constructing the removable motor
mounts. The 8" piece will be used in the next step.
22. Tie a loop in the middle of the 8" (200 mm) piece of
Kevlar. Pass the loop through the hole in the bulk-
head and glue the tails into place on the back side of
the bulkhead with wood glue. Allow the glue to dry.
Page 4
Instructions P/N 31249
Step 16
Step 17
Step 18
Step 19
Step 20
23"
580 mm
8"
Step 21
200 mm
Step 22
YES
NO
4"
100mm
8 ft section of
shock cord