Automatic Technology Australia Elite Installationsanleitung und Benutzerhandbuch - Seite 6
Blättern Sie online oder laden Sie pdf Installationsanleitung und Benutzerhandbuch für Toröffner Automatic Technology Australia Elite herunter. Automatic Technology Australia Elite 20 Seiten. Swing gate opener with remote control
I N S TA L L AT I O N O F M E C H A N I C A L D R I V E U N I T
MOUNTING OF DRIVE UNIT
STEP 2
1. Mount Drive Unit using four (4) 10mm loxins or
dynabolts.
2. Make sure that the Drive Unit is mounted at an
appropriate distance from the ground (Minimum
35mm to allow clearance for drive arm extension).
(Fig 1)
NOTE: If the gateway slopes away from pier/post
make sure an allowance is made for clearance of the
Drive Arm Extension and Slave Arm to not touch
the ground.
FIG. 3
PULL RING TO
DISENGAGE
MOTOR
AFFIXING ARMS AND BRACKETS TO GATE
STEP 3
1. Position gate in close position.
2. Assemble Drive Arm Extension to Drive Arm
(fixed to the drive unit) (Fig. 1), using two Hex.
Head screws and spring and flat washers supplied.
3. Assemble Slave Arm to Drive Arm Extension
(Fig. 1). Using plastic washers and shoulder screw
supplied.
4. Assemble Gate Mounting Bracket and Slave Arm
using shoulder screw and plastic washers (Fig 1),
don't tighten yet.
CHANGING TO/FROM MANUAL OPERATION
DISENGAGE DRIVE MOTOR, by pulling manual
engage/disengage pin up using the release ring fit-
ted, and while holding, rotate motor assembly in a
clockwise direction.
(Fig. 3 & 4)
( Later RE-ENGAGE DRIVE MOTOR rotate mo-
tor assembly in a anti-clockwise direction.)
DISENGAGED
POSITION
5.Extend arms out straight and mark position where
the Gate Mounting Bracket touches gate (Fig 5).
6. From this mark, measure 10mm toward Drive
Unit and mark again. This is where Gate Mounting
Bracket will be mounted (Fig. 5).
7.Remove the Gate Mounting Bracket from the
Slave Arm and secure the Gate Mounting Bracket
to the gate at second mark.
8.Reassemble Slave Arm to Gate Mounting Bracket
using shoulder screw and plastic washers. Secure
well.
Page. 6
FIG. 4
ROTATE MOTOR
CLOCKWISE TO
DISENGAGE
ENGAGED
POSITION