Galvin Engineering WaterMark 46664 Installations-Manuale - Seite 2

Blättern Sie online oder laden Sie pdf Installations-Manuale für Sanitärprodukt Galvin Engineering WaterMark 46664 herunter. Galvin Engineering WaterMark 46664 4 Seiten. Bs lever action sba

Seite drucken

Product Installation Guidelines

INSTALLATION

IMPORTANT: Galvin Specialised products must be installed in accordance with these installation instructions and

in accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water and/or electrical supply

conditions must also comply to the applicable national and/or state standards. Failing to comply with these

provisions shall void the product warranty and may affect the performance of the product.

Note: Tapware body used as an example only. SBAs can fit on different kinds of Ezy-Wash bodies.

1. Remove Handle

−

Prior to installation turn off the water supply.

−

Remove the handle assembly. To prevent

damage, carefully pry off plastic indicator from

the handle. (Use a small flat bladed screwdriver

if necessary).

3. Refit new head

Refit new head into tap body.

Note: do not tighten cartridge using the

handle as this will result in damage to the

cartridge

2. Replace spindle assembly

−

New ceramic head

New head

4. Reassemble Handle

Unscrew the head part from the threaded sleeve

using a 17mm spanner.

Check seat inside tap body for pitting or damage.

Re-seat if necessary

Refit adaptor and reassemble handle by

reversing step 1.

When installation is complete, slowly open

water supply and inspect for leaks.

Document Number: 001.00.70.13

Version 1, 4 November 2022, Page 2 of 4