Bristan 1500 Installationsanleitung und Benutzerhandbuch - Seite 8
Blättern Sie online oder laden Sie pdf Installationsanleitung und Benutzerhandbuch für Armaturen für das Badezimmer Bristan 1500 herunter. Bristan 1500 16 Seiten. Thermostatic power shower
Seite drucken
- 1. Table of Contents
- 2. Important Safety Information
- 3. Product Features
- 4. Electrical Requirements
- 5. Water Requirements
- 6. Fitting Your Shower
- 7. Fitting the Riser Rail
- 8. Commissioning - Testing the System
- 9. Operating the Shower
- 10. Adjusting the Showerhead
- 11. Cleaning & Maintenance
- 12. Troubleshooting
- 13. Spare Parts
- 14. Guarantee
- 15. Service Policy
Fitting your Shower
Fit the shower unit over the pipe work, and insert the mains wiring
through the aperture at the top of the base moulding. Ensure that
the supply pipes are fully inserted into the mixer valve 'push fit'
connections, and fix to the wall.
Connect the wiring in line with the polarity indications moulded into
the base unit.
Recessed Fitting Pipework
If the pipe work is to be recessed, it should be let into the wall with
the ends of the hot and cold pipes standing 40mm off the finished
surface of the wall, and centres 40mm apart, with the cold above the
hot. Connections to the hot and cold water supplies should be made
as described above, knocking out inlet holes in rear of unit.
Position the unit on the wall with the inlet pipes centred in the holes
in the rear of the base moulding, mark the fixing screw positions on
Hole Fixing Positions
the wall and remove the unit.
Drill the fixing screw holes and insert the wall plugs supplied.
Cut the plastic inlet elbows supplied to 40mm long from the centre
of the elbow, and remove any burrs from the cut end. Fit the cut
inlet elbows into the push-fit connectors on the shower mixer valve.
Flush out the pipe work.
Fit the shower unit over the pipe work, and insert the mains wiring
through the aperture at the top of the base moulding. Ensure that
the supply pipes are fully inserted into the mixer valve 'push fit'
connections, and fix to the wall using the fixing screws suppled.
Connect the wiring in line with the polarity indications moulded into
Wiring Connections
the base unit.
8
Need help? Give us a call on 0844 701 6273 and speak to one of our trained advisors.