Bristan 1500 설치 지침 및 사용자 설명서 - 페이지 8

{카테고리_이름} Bristan 1500에 대한 설치 지침 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Bristan 1500 16 페이지. Thermostatic power shower

Fitting your Shower

Fit the shower unit over the pipe work, and insert the mains wiring

through the aperture at the top of the base moulding. Ensure that

the supply pipes are fully inserted into the mixer valve 'push fit'

connections, and fix to the wall.

Connect the wiring in line with the polarity indications moulded into

the base unit.

Recessed Fitting Pipework

If the pipe work is to be recessed, it should be let into the wall with

the ends of the hot and cold pipes standing 40mm off the finished

surface of the wall, and centres 40mm apart, with the cold above the

hot. Connections to the hot and cold water supplies should be made

as described above, knocking out inlet holes in rear of unit.

Position the unit on the wall with the inlet pipes centred in the holes

in the rear of the base moulding, mark the fixing screw positions on

Hole Fixing Positions

the wall and remove the unit.

Drill the fixing screw holes and insert the wall plugs supplied.

Cut the plastic inlet elbows supplied to 40mm long from the centre

of the elbow, and remove any burrs from the cut end. Fit the cut

inlet elbows into the push-fit connectors on the shower mixer valve.

Flush out the pipe work.

Fit the shower unit over the pipe work, and insert the mains wiring

through the aperture at the top of the base moulding. Ensure that

the supply pipes are fully inserted into the mixer valve 'push fit'

connections, and fix to the wall using the fixing screws suppled.

Connect the wiring in line with the polarity indications moulded into

Wiring Connections

the base unit.

Need help? Give us a call on 0844 701 6273 and speak to one of our trained advisors.