Abacus Electric Evolve Sonix Benutzerhandbuch - Seite 2

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Sicherheitssystem Abacus Electric Evolve Sonix herunter. Abacus Electric Evolve Sonix 10 Seiten. Wireless gsm alarm

Seite drucken

Put the main alarm drive to the safe place so you prevent the manipulation. DO NOT PUT it to the metal

cupboard, the radio signal wouldn´t get through the metal.

The window/door sensor: insert the battery into the part „A". The magnetic sensor sends the signal to the

central drive if the two parts move away from each other to more than 2 – 3 cm. Attach the part „A" onto the

entrance door/window and the part „B" of the sensor onto the doorframe. You can check out the correctness of

the installation by opening the door – the red warning light will go on.

PIR sensor – insert the battery into the PIR sensor. PIR sensor uses the infrared technology for movement

detection. It is necessary to ensure that no small animals (dogs, cats, birds, and so on) will move in the guarded

compound. Do not place the sensor where the sun shines on it or where the switching heaters (heating

appliances, hotplates, heaters, storage heaters) on it. Place it into the guarded room under the ceiling to

prevent unwanted manipulation. The PIR sensor coverage is 5 - 12 metres, the range width horizontally

110°/vertically 60°.

Before the sensor installation, check if the sensors coverage and range meet your requirements.

Continue with the alarm installation as it is described in the part 7. The alarm configuration (User guide).

Installation guide:

1. Inserting the SIM card into the alarm

Press the yellow point on the device with the nib or another tip. The SIM card holder will slide out. Insert

the SIM card into it and slide it back. Make sure that the SIM card´s metal contacts are downwards. Now

press the SIM card holder back into the device. Before inserting the SIM card into the alarm, use it first in

the normal mobile phone and make these steps:

- Delete the PIN code

- Delete all the saved numbers, if there are any on the SIM card

2. Connecting the antenna

Screw the antenna carefully onto the main drive. Do not leave it too loose and do not screw it too tight

either!

3. Connecting the power supply

Connect the power supply adaptor that must have the voltage in the range 9V - 12V DC and must provide

the current over 1000 mA into the alarm main drive. The signal LED diode on the alarm will go red for 20

seconds. It waits for the connection of the detectors to the main drive during this time. After 20 seconds

the LED signal will blink orange, which means that the main drive checks the SIM card and searches the

GSM net. After finishing this phase the signal LED diode will change to the slowly blinking green colour,

which means that the telephone numbers were saved into the alarm and the device is turned on to the

active alarm mode. If the signal LED diode stays shine with continuous green colour without blinking it

means that the telephone numbers weren´t saved and the device is turned on without the activated

Door / window sensor