Abacus Electric Evolve Sonix Podręcznik użytkownika - Strona 2
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla System bezpieczeństwa Abacus Electric Evolve Sonix. Abacus Electric Evolve Sonix 10 stron. Wireless gsm alarm
Put the main alarm drive to the safe place so you prevent the manipulation. DO NOT PUT it to the metal
cupboard, the radio signal wouldn´t get through the metal.
The window/door sensor: insert the battery into the part „A". The magnetic sensor sends the signal to the
central drive if the two parts move away from each other to more than 2 – 3 cm. Attach the part „A" onto the
entrance door/window and the part „B" of the sensor onto the doorframe. You can check out the correctness of
the installation by opening the door – the red warning light will go on.
PIR sensor – insert the battery into the PIR sensor. PIR sensor uses the infrared technology for movement
detection. It is necessary to ensure that no small animals (dogs, cats, birds, and so on) will move in the guarded
compound. Do not place the sensor where the sun shines on it or where the switching heaters (heating
appliances, hotplates, heaters, storage heaters) on it. Place it into the guarded room under the ceiling to
prevent unwanted manipulation. The PIR sensor coverage is 5 - 12 metres, the range width horizontally
110°/vertically 60°.
Before the sensor installation, check if the sensors coverage and range meet your requirements.
Continue with the alarm installation as it is described in the part 7. The alarm configuration (User guide).
Installation guide:
1. Inserting the SIM card into the alarm
Press the yellow point on the device with the nib or another tip. The SIM card holder will slide out. Insert
the SIM card into it and slide it back. Make sure that the SIM card´s metal contacts are downwards. Now
press the SIM card holder back into the device. Before inserting the SIM card into the alarm, use it first in
the normal mobile phone and make these steps:
- Delete the PIN code
- Delete all the saved numbers, if there are any on the SIM card
2. Connecting the antenna
Screw the antenna carefully onto the main drive. Do not leave it too loose and do not screw it too tight
either!
3. Connecting the power supply
Connect the power supply adaptor that must have the voltage in the range 9V - 12V DC and must provide
the current over 1000 mA into the alarm main drive. The signal LED diode on the alarm will go red for 20
seconds. It waits for the connection of the detectors to the main drive during this time. After 20 seconds
the LED signal will blink orange, which means that the main drive checks the SIM card and searches the
GSM net. After finishing this phase the signal LED diode will change to the slowly blinking green colour,
which means that the telephone numbers were saved into the alarm and the device is turned on to the
active alarm mode. If the signal LED diode stays shine with continuous green colour without blinking it
means that the telephone numbers weren´t saved and the device is turned on without the activated
Door / window sensor
43