360 YIELD CENTER 360 BANDIT Einbauanleitung - Seite 2

Blättern Sie online oder laden Sie pdf Einbauanleitung für Landwirtschaftliche Geräte 360 YIELD CENTER 360 BANDIT herunter. 360 YIELD CENTER 360 BANDIT 4 Seiten.
Auch für 360 YIELD CENTER 360 BANDIT: Einbauanleitung (2 seiten)

Seite drucken
INSTALLATION INSTRUCTIONS
HARVEST INTERNATIONAL
BEFORE YOU BEGIN...
HELPFUL TOOLS
Hammer/Mallet
Wrench Sizes: 15/16" and 3/4"
Socket Sizes: 15/16" and 3/4"
Impact Driver/ Socket Wrench
Torque Wrench
Side Cutters
STEP 1
REMOVE CLOSING SYSTEM
1
4
Remove the hair clip and pin from row unit 1 and slide the
closing system 2 off.
If present, remove insecticide attachment.
Using an 3/4" socket remove the two bolts 3 that attach
the closing system plate 4 to the row unit. Bolts can be
discarded but the plate should be retained.
PAGE 2
STEP 2
INSTALL BANDIT UNIT
2
5
3
Using the two short 1/2" bolts 5 attach the 360 BANDIT
unit (long leg to the rear) to the row unit where the closing
system plate was just removed.
Tighten with 3/4" socket. Torque bolts to 57 ft lbs. Ensure
not to over tighten bolts.
NOTE: The supplied 3/8" x 1" bolt installed in the BANDIT
pin up hole is to be used as a "zero" setting and as a stop in
case of spring disengagement.
5