HP ProCurve 1600M Handbuch Ergänzung - Seite 19

Displaying VRRP Configuration Information and Statistics

You can use the CLI or Web management interface to display configuration information and statistics for VRRP.

To display VRRP configuration information for an HP routing switch, use one of the following methods.

USING THE CLI

To display VRRP configuration information for a router, enter the following command:

Router1(config)# show ip vrrp

Here is an example of the information displayed by this command:

Total number of VRRP routers defined: 1

Interface ethernet e 1/6

auth-type no authentication

VRID 1

state master

administrative-status activated

mode owner

priority 255

current priority 255

hello-interval 1 sec

ip-address 192.53.5.1

USING THE WEBMANAGEMENT INTERFACE

To display VRRP configuration information, select VRRP from the System configuration sheet. A panel such as

the ones shown in Figure 5 and Figure 6 is displayed.

•

To modify an entry, select Modify.

•

To delete an entry, select Delete.

NOTE: If you delete the real IP address associated with a VRRP entry, the VRRP entry also is deleted

automatically.

Configuring VRRP