HP ProCurve 1600M Installationshandbuch - Seite 5

Fan Tray Installation Steps

Follow these steps to install the replacement fan tray into the back of the Switch 4000M

or 8000M:

1. Disconnect AC power and remove power supplies and back cover plates.

On the back of the switch, dis-

connect all AC power. Then,

loosen the 4 screws holding in

each power supply or cover

plate, and remove the power

supplies and cover plates

2. Mark and disconnect the network cables on modules in slots A and B.

On the front of the switch, mark or otherwise note the location of the network

cables attached to the network modules in switch slots A and B so that you can

reconnect the cables to the correct ports at the end of this procedure. Then,

disconnect all network cables from modules that are installed in slots A and B

on the front of the switch.

Alternatively, if you have sufficient slack in the cables, you can leave the network

cables connected to the modules as you complete the next step.

3. Remove the Management module and any modules that you have

installed in slots A and B.

Loosen the two screws holding

in each module, and use the

screws to slide the modules

out. Remember which module

is located in which slot.

Caution: When handling the mod-

ules, do not touch the components

on the module boards or the edge

connectors. Otherwise, damage

due to static discharge could

occur.