Olympus BX41 Anleitung Handbuch - Seite 3

Blättern Sie online oder laden Sie pdf Anleitung Handbuch für Mikroskop Olympus BX41 herunter. Olympus BX41 34 Seiten. System microscope
Auch für Olympus BX41: Anleitung Handbuch (36 seiten)

Seite drucken

IMPORTANT

This microscope employs a UIS (Universal Infinity System) optical design, and should be used only with

UIS eyepieces, objectives and condensers for the BX2 series. (Some of the modules designed for the BX

series are also usable. For details, please consult Olympus or the catalogue.) Less than optimum perfor-

mance may result if inappropriate accessories are used.

SAFETY PRECAUTIONS

Fig. 1

Fig. 2

1. Install the microscope on a sturdy, level table or bench so as not to block

the air vents on the underside of the base.

Do not place the microscope on a flexible surface, as this could result in

blocking the air vents and cause overheating or a fire.

2. To prevent obstruction of the natural convection-based air cooling of the

microscope, make sure to leave at least 10 cm of free space between

walls or other objects, and the left, right and rear sides of the microscope

and the lamp socket when installing the microscope.

3. To avoid potential shock hazards and burns when replacing the light

bulb, set the main switch @ to "

cord from the wall outlet in advance. Whenever you replace the bulb

during use or right after use, allow the lamp socket ² and bulb to cool

before touching. (Figs. 1 & 2)

Designated bulb

# The microscope also incorporate a fuse (this should be replaced by

the manufacturer or authorized agent).

4. Make sure the voltage selector switch ³ located on the rear side of the

microscope frame is set to conform with the local supply voltage. (When

shipped from the factory, the switch is set to 220-240 V.)

5. Always use the power cord provided by Olympus. If no power cord is

provided, please select the proper power cord by referring to the section

"PROPER SELECTION OF THE POWER SUPPLY CORD" at the end of

this instruction manual. If the proper power cord is not used, product

safety and performance cannot be guaranteed.

6. Always ensure that the grounding terminal of the microscope and that

of the wall outlet are properly connected. If the equipment is not grounded,

Olympus can no longer warrant the electrical safety and performance of

the equipment.

7. Never insert metallic objects into the air vents of the microscope frame

as this could result in electrical shock, personal injury and equipment

damage.

8. The power cord may be melt by the heat of lamp socket if the cord

comes in contact with it. Distribute the power cord at an enough dis-

tance from the lamp socket.

" (OFF) then disconnect the power

6V30WHAL (PHILIPS 5761)

(Fig. 1)