CREE LIGHTING IG Series Einbauanleitung

Blättern Sie online oder laden Sie pdf Einbauanleitung für Lantern CREE LIGHTING IG Series herunter. CREE LIGHTING IG Series 4 Seiten. Wireless led parking luminaire

Seite drucken

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should always be followed

including the following:

READ AND FOLLOW ALL SAFETY

DANGER- Risk of shock- Disconnect power before installation.

DANGER – Risque de choc – Couper l'alimentation avant l'installation.

This luminaire must be installed in accordance with the NEC or your local electrical

code.

If you are not familiar with these codes and requirements, consult a qualified

electrician.

Ce produit doit être installé conformément à NEC ou votre code électrique local.

Si vous n'êtes pas familier avec ces codes et ces exigences, veuillez contacter un

électricien qualifié.

USE MIN. 90°C SUPPLY CONDUCTORS for 120-277V luminaires and USE MIN

75°C SUPPLY CONDUCTORS for the 347V luminaires.

LES FILS D'ALIMENTATION 90°C MIN pour 120-277V et LES FILS

D'ALIMENTATION 75°C MIN pour 347V .

DO NOT lift luminaire by the power leads.

DO NOT carry or lift luminaire by Splice Inspection Tether or wireform. Splice

Inspection Tether and wireform are only for supporting luminaire while making

wiring connections.

SAVE THESE INSTRUCTIONS FOR FUTURE

TO INSTALL:

Mounting Plate

Splice Inspection Tether

Screw Hole

Use these 2 slots for

mounting to junction box.

1 of 4

INSTRUCTIONS

REFERENCE

Splice Inspection

Tether

Mounting Plate

Wireless LED Parking Luminaire

INSTRUCTIONS D'INSTALLATION

NOTE:

• During installation and maintenance handle

the luminaire only by the housing NOT by the

lens.

JUNCTION BOX MOUNTING

NOTE: "J" Input Power Designator comes with

Splice Inspection Tether only. "A" Input Power

Designator comes with a Splice Inspection

Tether or wireform.

STEP 1:

WITH SPLICE INSPECTION TETHER

Locate the Splice Inspection Tether on

the luminaire and attach the cable to the

designated screw hole on the mounting plate

Mounting

using the provided screws. See Figure 1.

Plate Tab

STEP 2:

WITH SPLICE INSPECTION TETHER

NOTE: Ensure to install mounting plate to

junction box using the two screws slots on the

mounting plate that are diagonal to the Splice

Inspection Tether. See Figure 1.

NOTE: Two people may be needed for

installing to junction box, one to hold the

Splice Inspection

luminaire and another to install the mounting

Tether

plate to the junction box.

Attach mounting plate to customer supplied

junction box with the tabs on the Mounting

Plate directed parallel to vehicle traffic as

shown in Figure 2. Torque to 20 in-lbs. See

Figure 2 and 3.

STEP 3:

Make wiring connections per "Electrical

Connections" section.

IG Series

Junction Box and Pendant Mount

INSTALLATION INSTRUCTIONS

LPN00305X0012A0_A