CREE LIGHTING IG Series Einbauanleitung - Seite 2

Blättern Sie online oder laden Sie pdf Einbauanleitung für Lantern CREE LIGHTING IG Series herunter. CREE LIGHTING IG Series 4 Seiten. Wireless led parking luminaire

Seite drucken

Mounting

Plate

(4) Luminaire Slots

Luminaire

Slots

STEP 4:

After wiring connections have been made, tuck

all wires into junction box ensuring that no

wires are pinched.

STEP 5:

Attach luminaire to the Mounting Plate by

pressing up on the luminaire until the slots

on the luminaire engage with the tabs on

the Mounting Plate and rotate until tabs lock

securely. To secure install a minimum of (2)

supplied screws across from each other into

the mounting plate tabs on the underside of

the luminaire. See Figure 4.

NOTE: May require extra pressure on luminaire

to engage tabs into slots. Only apply pressure

on housing body NOT on the luminaire lens.

NOTE: If the mounting plate tabs become

deformed during installation, slightly reopen

the tabs back up using a screwdriver to ensure

proper install of luminaire.

STEP 6:

Lightly pull on the luminaire to verify luminaire

is securely mounted.

FIXTURE SERVICING AND

MAINTENANCE

STEP 1:

If supply wiring splices need to be inspected

or if luminaire needs to be removed, fully

loosen the (2) screws and rotate luminaire to

disengage from Mounting Plate.

STEP 2:

To re-install luminaire, when finished with

servicing or maintenance follow Step 2-6 in

"Junction Box Mounting" section above.

2 of 4

(4) Tabs

View of Underneath

(2) Screws

Luminaire

(4) Mounting

Plate Tabs

PENDANT MOUNTING (OPTIONAL)

NOTE: Customer supplied 3/4" IP Pendant

Kit and wire leads may be necessary for

pendant mounting. For existing rigid pendant

installations, perform Step 2 through 8 only.

Not recommended for use with a hang straight

pendant. Cree Lighting does not provide a

counterbalance system.

STEP 1:

Feed wire leads through customer supplied

pendant kit. See Figure 5. Make sure leads are

at least 6 in longer than customer supplied

pendant stem.

STEP 2:

WITH SPLICE INSPECTION TETHER ( A or J

Input Power Designator)

Locate the Splice Inspection Tether on

the luminaire and attach the cable to the

designated screw hole on the Pendant

Mounting Plate using the provided screws. See

Figure 1 and 2.

STEP 3:

WITH SPLICE INSPECTION TETHER ( A or J

Input Power Designator)

NOTE: Two people may be needed for installing

to customer supplied pendant kit, one to

hold the luminaire and another to install the

Pendant Mounting Plate to the customer

supplied pendant kit.

Attach Pendant Mounting Plate to customer

supplied pendant kit. See Figure 5.

STEP 4:

Feed wire leads through the Water Shield.

NOTE: Water Shield will be held in place by

the Pendant Mounting Plate. No fasteners are

necessary.

Pendant Kit

(Supplied by

Customer)

Splice Inspection

Tether

Pendant Mounting

Plate

Water Shield

Luminaire

STEP 5:

Make wiring connections to customer supplied

wire leads per "Electrical Connections"

section.

LPN00305X0012A0_A