Cisco ASR 920 series Handbuch zur Installation - Seite 27
Blättern Sie online oder laden Sie pdf Handbuch zur Installation für Schalter Cisco ASR 920 series herunter. Cisco ASR 920 series 42 Seiten. Aggregation services router
Auch für Cisco ASR 920 series: Handbuch zur Installation (36 seiten), Erste Schritte (6 seiten), Hardware-Installationshandbuch (46 seiten), Handbuch (36 seiten)
Seite drucken
Installing the Cisco ASR 920 Series Router
Perform the following procedure to ground the router using a 2-hole lug and the corresponding mounting
point. Most carriers require a minimum 6-AWG ground connection. Verify your carrier's requirements for
the ground connection.
SUMMARY STEPS
1. If your ground wire is insulated, use a wire-stripping tool to strip the ground wire to 0.5 inch ± 0.02 inch
(12.7 mm ±0.5 mm) (See the figure below).
2. Slide the open end of your 2-hole ground lug over the exposed area of the ground wire.
3. Using a crimping tool (as specified by the ground lug manufacturer), crimp the ground lug to the ground
wire as shown in the figure below.
4. Use a Phillips head screwdriver to attach the 2-hole ground lug and wire assembly to the router with the
2 pan-head Phillips head screws.
5. Connect the other end of the ground wire to a suitable grounding point at your site.
DETAILED STEPS
Step 1
If your ground wire is insulated, use a wire-stripping tool to strip the ground wire to 0.5 inch ± 0.02 inch (12.7 mm ±0.5
mm) (See the figure below).
Figure 21: Stripping a Ground Wire
Cisco ASR 920 Series Aggregation Services Router Hardware Installation Guide
Install the Chassis Ground Connection
27