Cisco ASR 920 series Handleiding installeren - Pagina 27
Blader online of download pdf Handleiding installeren voor {categorie_naam} Cisco ASR 920 series. Cisco ASR 920 series 42 pagina's. Aggregation services router
Ook voor Cisco ASR 920 series: Handleiding installeren (36 pagina's), Aan de slag (6 pagina's), Hardware installatiehandleiding (46 pagina's), Handmatig (36 pagina's)
Pagina afdrukken
Installing the Cisco ASR 920 Series Router
Perform the following procedure to ground the router using a 2-hole lug and the corresponding mounting
point. Most carriers require a minimum 6-AWG ground connection. Verify your carrier's requirements for
the ground connection.
SUMMARY STEPS
1. If your ground wire is insulated, use a wire-stripping tool to strip the ground wire to 0.5 inch ± 0.02 inch
(12.7 mm ±0.5 mm) (See the figure below).
2. Slide the open end of your 2-hole ground lug over the exposed area of the ground wire.
3. Using a crimping tool (as specified by the ground lug manufacturer), crimp the ground lug to the ground
wire as shown in the figure below.
4. Use a Phillips head screwdriver to attach the 2-hole ground lug and wire assembly to the router with the
2 pan-head Phillips head screws.
5. Connect the other end of the ground wire to a suitable grounding point at your site.
DETAILED STEPS
Step 1
If your ground wire is insulated, use a wire-stripping tool to strip the ground wire to 0.5 inch ± 0.02 inch (12.7 mm ±0.5
mm) (See the figure below).
Figure 21: Stripping a Ground Wire
Cisco ASR 920 Series Aggregation Services Router Hardware Installation Guide
Install the Chassis Ground Connection
27