Siemens SINAMICS G120P Betriebsanleitung - Seite 21

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Industrielle Ausrüstung Siemens SINAMICS G120P herunter. Siemens SINAMICS G120P 28 Seiten. Line reactors for power modules pm330
Auch für Siemens SINAMICS G120P: Betriebsanleitung (26 seiten), Betriebsanleitung (34 seiten), Betriebsanleitung (24 seiten), Betriebsanleitung (22 seiten), Betriebsanleitung (26 seiten), Betriebsanleitung (22 seiten), Betriebsanleitung (22 seiten), Handbuch (18 seiten), Betriebsanleitung (18 seiten)

Connection

When connecting the du/dt reactor and Voltage Peak Limiter, you must take into account the

following conditions to ensure that it functions correctly:

● Control cables must be routed separately from power cables. Power cables are the motor

● It is recommended to use shielded motor cables. If a shielded motor cable is used, its

● The ground wire for the motor must be fed directly back to the Power Module.

Connection overview

Figure 4-3

Cable cross-sections

Table 4- 1

Cable cross-sections for connections between the du/dt filter plus Voltage Peak Limiter and Power Module

du/dt filter plus Voltage Peak

Limiter

6SL3000-2DE35-0AA0

6SL3000-2DE38-4AA0

dV/dt filter plus Voltage Peak Limiter

Operating Instructions, 04/2014, A5E32847105B AB

cable or the connecting cables from the DC link of the Power Module (terminals

DCP/DCN) to the Voltage Peak Limiter. In particular, you must ensure that control cables

and power cables are not routed in parallel in a joint cable raceway, even if all the cables

are shielded.

shield should be connected through a large surface area with the shield connection plate

in the cabinet and at the motor housing.

Connecting a du/dt filter plus Voltage Peak Limiter

Connection to the DC link

(DCPS/DCNS)

Line voltage 380 V – 480 V 3 AC

[mm²]

2 x 50

Electrical installation

Connection between du/dt reactor and

voltage peak limiter

(1U2, 1V2, 1W2) [mm²]