Siemens SINAMICS G120P 사용 설명서 - 페이지 21

{카테고리_이름} Siemens SINAMICS G120P에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SINAMICS G120P 28 페이지. Line reactors for power modules pm330
Siemens SINAMICS G120P에 대해서도 마찬가지입니다: 사용 설명서 (26 페이지), 사용 설명서 (34 페이지), 사용 설명서 (24 페이지), 사용 설명서 (22 페이지), 사용 설명서 (26 페이지), 사용 설명서 (22 페이지), 사용 설명서 (22 페이지), 매뉴얼 (18 페이지), 사용 설명서 (18 페이지)

페이지 인쇄

1. Maintenance and Servicing

Connection

When connecting the du/dt reactor and Voltage Peak Limiter, you must take into account the

following conditions to ensure that it functions correctly:

● Control cables must be routed separately from power cables. Power cables are the motor

● It is recommended to use shielded motor cables. If a shielded motor cable is used, its

● The ground wire for the motor must be fed directly back to the Power Module.

Connection overview

Figure 4-3

Cable cross-sections

Table 4- 1

Cable cross-sections for connections between the du/dt filter plus Voltage Peak Limiter and Power Module

du/dt filter plus Voltage Peak

Limiter

6SL3000-2DE35-0AA0

6SL3000-2DE38-4AA0

dV/dt filter plus Voltage Peak Limiter

Operating Instructions, 04/2014, A5E32847105B AB

cable or the connecting cables from the DC link of the Power Module (terminals

DCP/DCN) to the Voltage Peak Limiter. In particular, you must ensure that control cables

and power cables are not routed in parallel in a joint cable raceway, even if all the cables

are shielded.

shield should be connected through a large surface area with the shield connection plate

in the cabinet and at the motor housing.

Connecting a du/dt filter plus Voltage Peak Limiter

Connection to the DC link

(DCPS/DCNS)

Line voltage 380 V – 480 V 3 AC

[mm²]

2 x 50

Electrical installation

Connection between du/dt reactor and

voltage peak limiter

(1U2, 1V2, 1W2) [mm²]