Cisco Catalyst IW9165E Schnellstart-Handbuch - Seite 13

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Drahtloser Zugangspunkt Cisco Catalyst IW9165E herunter. Cisco Catalyst IW9165E 16 Seiten.

Seite drucken

Installation Overview

Connecting an Ethernet Cable to the Access Point

Connect an Ethernet cable to the access point by using a cable gland or an M12-RJ45 adapter.

Connecting an Ethernet Cable to the Access Point

Follow these steps to connect an Ethernet cable to the RJ-45 port:

Step 1

Disconnect power to the power injector, and ensure all power sources to the access point are turned off.

Step 2

Insert the RJ-45 cable connector into the Ethernet port opening on the access point as shown in the following figure:

RJ-45 port

Step 3

Ensure that the antennas are connected to the access point before you apply power to the access point.

Connecting to the RJ-45 Port Using M12 Adapter

Follow these steps to connect to the RJ-45 port using M12 adapter:

Step 1

Ensure the O-rings are on the M12 adapter and spacer.

Connecting an Ethernet Cable to the Access Point

RJ-45 cable

Installation Overview