Cisco Catalyst IW9165E 빠른 시작 매뉴얼 - 페이지 13
{카테고리_이름} Cisco Catalyst IW9165E에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst IW9165E 16 페이지.
페이지 인쇄Installation Overview
Connecting an Ethernet Cable to the Access Point
Connect an Ethernet cable to the access point by using a cable gland or an M12-RJ45 adapter.
Connecting an Ethernet Cable to the Access Point
Follow these steps to connect an Ethernet cable to the RJ-45 port:
Step 1
Disconnect power to the power injector, and ensure all power sources to the access point are turned off.
Step 2
Insert the RJ-45 cable connector into the Ethernet port opening on the access point as shown in the following figure:
1
RJ-45 port
Step 3
Ensure that the antennas are connected to the access point before you apply power to the access point.
Connecting to the RJ-45 Port Using M12 Adapter
Follow these steps to connect to the RJ-45 port using M12 adapter:
Step 1
Ensure the O-rings are on the M12 adapter and spacer.
Connecting an Ethernet Cable to the Access Point
2
RJ-45 cable
Installation Overview
13