Cisco Catalyst IW9165E Panduan Memulai Cepat - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Titik Akses Nirkabel Cisco Catalyst IW9165E. Cisco Catalyst IW9165E 16 halaman.

Halaman Cetak
Installation Overview

Connecting an Ethernet Cable to the Access Point

Connect an Ethernet cable to the access point by using a cable gland or an M12-RJ45 adapter.
Connecting an Ethernet Cable to the Access Point
Follow these steps to connect an Ethernet cable to the RJ-45 port:
Step 1
Disconnect power to the power injector, and ensure all power sources to the access point are turned off.
Step 2
Insert the RJ-45 cable connector into the Ethernet port opening on the access point as shown in the following figure:
1
RJ-45 port
Step 3
Ensure that the antennas are connected to the access point before you apply power to the access point.
Connecting to the RJ-45 Port Using M12 Adapter
Follow these steps to connect to the RJ-45 port using M12 adapter:
Step 1
Ensure the O-rings are on the M12 adapter and spacer.
Connecting an Ethernet Cable to the Access Point
2
RJ-45 cable
Installation Overview
13