Digitrax DN166I1D Handbuch - Seite 3

Blättern Sie online oder laden Sie pdf Handbuch für Medienkonverter Digitrax DN166I1D herunter. Digitrax DN166I1D 8 Seiten.

Installation Notes

Do not exceed the decoder's

500mA total function output

rating.

We recommend that the Blue

wire, also called +Common or

Lamp Common, be connected

as shown. If you wish to omit

the Blue wire in your instal-

lation, consult the Digitrax

Decoder Manual for more

information.

The head lamp should

be hooked up using the

Blue/+Common wire for

optimal Digitrax transponding

operation.

To use a function output with

an inductive (coil) type load, see

the Digitrax Decoder Manual

for more information to avoid

damage to the decoder.

See the Digitrax Decoder Man-

ual for full details of wiring 12-16V lamps, 1.5V lamps, and LEDs. Lamps that

draw more than 80 mA when running require a 22 ohm 1/4 watt resistor in

series with the directional light function lead to protect the decoder.

Some locomotives employ filter capacitors for RFI suppression in the loco-

motive wiring. These may cause problems with Supersonic decoders and

non-decoder analog operation on DCC. This capacitor should be removed for

safe operation.

Figure 3: Wires unsoldered from

light board.

Figure 4: Wires soldered onto

the DN166ID

— 3 —

Wires soldered on.