- ページ 3
メディア・コンバーター Digitrax DN166I1DのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Digitrax DN166I1D 8 ページ。
ページを印刷する
Installation Notes
1.
Do not exceed the decoder's
500mA total function output
rating.
2.
We recommend that the Blue
wire, also called +Common or
Lamp Common, be connected
as shown. If you wish to omit
the Blue wire in your instal-
lation, consult the Digitrax
Decoder Manual for more
information.
3.
The head lamp should
be hooked up using the
Blue/+Common wire for
optimal Digitrax transponding
operation.
4.
To use a function output with
an inductive (coil) type load, see
the Digitrax Decoder Manual
for more information to avoid
damage to the decoder.
5.
See the Digitrax Decoder Man-
ual for full details of wiring 12-16V lamps, 1.5V lamps, and LEDs. Lamps that
draw more than 80 mA when running require a 22 ohm 1/4 watt resistor in
series with the directional light function lead to protect the decoder.
6.
Some locomotives employ filter capacitors for RFI suppression in the loco-
motive wiring. These may cause problems with Supersonic decoders and
non-decoder analog operation on DCC. This capacitor should be removed for
safe operation.
© 2014 Digitrax, Inc.
Figure 3: Wires unsoldered from
light board.
Figure 4: Wires soldered onto
the DN166ID
— 3 —
Wires soldered on.
www.digitrax.com