Digitrax DN166I1D Manuale - Pagina 3

Sfoglia online o scarica il pdf Manuale per Convertitore multimediale Digitrax DN166I1D. Digitrax DN166I1D 8.

Installation Notes

Do not exceed the decoder's

500mA total function output

rating.

We recommend that the Blue

wire, also called +Common or

Lamp Common, be connected

as shown. If you wish to omit

the Blue wire in your instal-

lation, consult the Digitrax

Decoder Manual for more

information.

The head lamp should

be hooked up using the

Blue/+Common wire for

optimal Digitrax transponding

operation.

To use a function output with

an inductive (coil) type load, see

the Digitrax Decoder Manual

for more information to avoid

damage to the decoder.

See the Digitrax Decoder Man-

ual for full details of wiring 12-16V lamps, 1.5V lamps, and LEDs. Lamps that

draw more than 80 mA when running require a 22 ohm 1/4 watt resistor in

series with the directional light function lead to protect the decoder.

Some locomotives employ filter capacitors for RFI suppression in the loco-

motive wiring. These may cause problems with Supersonic decoders and

non-decoder analog operation on DCC. This capacitor should be removed for

safe operation.

Figure 3: Wires unsoldered from

light board.

Figure 4: Wires soldered onto

the DN166ID

— 3 —

Wires soldered on.