Cisco UBR7246VXR Hardware-Installation - Seite 10

Blättern Sie online oder laden Sie pdf Hardware-Installation für Netzwerk-Hardware Cisco UBR7246VXR herunter. Cisco UBR7246VXR 25 Seiten. Universal broadband router
Auch für Cisco UBR7246VXR: Schnellstart-Handbuch (27 seiten), Benutzerhandbuch (7 seiten), Installationshandbuch (28 seiten)

Seite drucken

Figure 5

Installing the Rack-Mount Brackets so the Front of the Chassis Is Flush with the Rack

Rack-mount bracket

Note

You cannot use the cable management bracket in this configuration.

Figure 6

Installing the Rack-Mount Brackets so the Front of the Chassis Protrudes Out of the Rack

Rack-mount bracket

Attach the Rack-Mount Brackets to the Middle of the Chassis

To install the rack-mount brackets for an open or relay-type rack-mount configurations, complete the following steps:

Step 1

Locate the threaded holes in the middle sides of the chassis.

Step 2

Align the first rack-mount bracket to the threaded holes in the right side of the chassis, as shown in Figure 7. Use either

set of four holes to align the bracket to the threaded holes in the sides of the chassis.

Step 3

Thread the four M4 x 6-mm Phillips flathead screws through the rack-mount bracket and into the side of the chassis.

Use a number 2 Phillips screwdriver to tighten the screws.

Step 4

Repeat Step 1 through Step 3 to attach the other rack-mount bracket.

Step 5

See the "Installing the Cable-Management Brackets" section on page 11 for cable management bracket instructions.

Rack-mount bracket