3D AEROWORKS Pilatus PC-21 Montageanleitung und Benutzerhandbuch - Seite 11
Blättern Sie online oder laden Sie pdf Montageanleitung und Benutzerhandbuch für Spielzeug 3D AEROWORKS Pilatus PC-21 herunter. 3D AEROWORKS Pilatus PC-21 19 Seiten.
Seite drucken
13
Cut four 15mm sections (2 per wing) of skewer. Insert the 15mm sections into the wings.
These will assist in aligning the wings when joining to the fuselage.
Glue the wings to the fuselage NOTE – if using 3mm x 0.6mm carbon strip, now is the time
to install it. Simply slide the carbon strip into the slot and cut it so it does not protrude out of
the wing (circled in red, see image). The cross structure of the fuselage spreads the load of
the wings at the root which negates the need of a connecting spar in the fuselage.
14
Run a string through the aileron servo wire tube from the mount hole for the aileron servo to
the wing root. Leave enough length so that you will be able to feed the string through the
fuse later.
15
Install all servos using a small amount of hot glue to secure it in place. The aileron servos
mounting tabs will need to be trimmed. Connect the ailerons to the servos using 1mm wire
and the printed linkage locks.