3D AEROWORKS Pilatus PC-21 Manuale di montaggio e manuale d'uso - Pagina 11

Sfoglia online o scarica il pdf Manuale di montaggio e manuale d'uso per Giocattolo 3D AEROWORKS Pilatus PC-21. 3D AEROWORKS Pilatus PC-21 19.

Cut four 15mm sections (2 per wing) of skewer. Insert the 15mm sections into the wings.

These will assist in aligning the wings when joining to the fuselage.

Glue the wings to the fuselage NOTE – if using 3mm x 0.6mm carbon strip, now is the time

to install it. Simply slide the carbon strip into the slot and cut it so it does not protrude out of

the wing (circled in red, see image). The cross structure of the fuselage spreads the load of

the wings at the root which negates the need of a connecting spar in the fuselage.

Run a string through the aileron servo wire tube from the mount hole for the aileron servo to

the wing root. Leave enough length so that you will be able to feed the string through the

fuse later.

Install all servos using a small amount of hot glue to secure it in place. The aileron servos

mounting tabs will need to be trimmed. Connect the ailerons to the servos using 1mm wire

and the printed linkage locks.