3D AEROWORKS Pilatus PC-21 조립 설명서 및 사용자 설명서 - 페이지 11

{카테고리_이름} 3D AEROWORKS Pilatus PC-21에 대한 조립 설명서 및 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D AEROWORKS Pilatus PC-21 19 페이지.

Cut four 15mm sections (2 per wing) of skewer. Insert the 15mm sections into the wings.

These will assist in aligning the wings when joining to the fuselage.

Glue the wings to the fuselage NOTE – if using 3mm x 0.6mm carbon strip, now is the time

to install it. Simply slide the carbon strip into the slot and cut it so it does not protrude out of

the wing (circled in red, see image). The cross structure of the fuselage spreads the load of

the wings at the root which negates the need of a connecting spar in the fuselage.

Run a string through the aileron servo wire tube from the mount hole for the aileron servo to

the wing root. Leave enough length so that you will be able to feed the string through the

fuse later.

Install all servos using a small amount of hot glue to secure it in place. The aileron servos

mounting tabs will need to be trimmed. Connect the ailerons to the servos using 1mm wire

and the printed linkage locks.