3D Hobby Shop 70 AJ SLICK Montageanleitung - Seite 10

Blättern Sie online oder laden Sie pdf Montageanleitung für Spielzeug 3D Hobby Shop 70 AJ SLICK herunter. 3D Hobby Shop 70 AJ SLICK 19 Seiten.

Seite drucken
10
Use a lock nut to tighten the ball link into the rudder control horn. Assemble the cables
onto the pull-wire ends, pulling the cables snug before crimping. We do not need the cables
to be extremely tight, just snug and without sagging. Use the threaded pull-cable ends,
screwing them into the ball joints as necessary, to tighten the cables.
Remove the covering over the wing spar tube hole, the wing bolt hole, and the other holes
in the front of the fuselage as shown.
Remove covering over the horizontal stabilizer opening. Insert horizontal stabilizer – DO
NOT GLUE YET. Temporarily install the wings onto the fuselage.