3d-printz Naughty 2000 Anleitung Handbuch - Seite 7

Blättern Sie online oder laden Sie pdf Anleitung Handbuch für Spielzeug 3d-printz Naughty 2000 herunter. 3d-printz Naughty 2000 9 Seiten.

yet!) . The fuselage parts are best glued with thick CA without accelerator or epoxy

resin, so that there is enough time for the alignment of the tube. Finally, the front

can be connected to the back.

For the canopy glue together canopy_front and canopy_rear, mount the

magnetholder with 2x M2 Screws to the fuselage (above the servos), and glue in the

magnets to the canopy and magnetholer (keep polarization in mind)

stab

Glue the parts El_right, El_middle and El_left and the corresponding rudder

surfaces together (4mm carbon tube obligatory!)

Then screw the entire horizontal stab to the pylon using M5 and M3 screws and the

associated nuts (these are pushed into the slots in the pylon). The tailplane must be

parallel to the wing - therefore, as a guide, mount the wing center section on the

fuselage with 2x M6 screws, apply adhesive to the pylon (the tailplane is already

screwed on) and glue the pylon to the fuselage so that the tailplane is parallel to

the wing.

Then the vertical stabilizer, the rudder (TPU hinges) and the skid can be aligned

and glued in the same way.

electronics