Camille Bauer SINEAX V604s Betriebsanleitung - Seite 14

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Transmitter Camille Bauer SINEAX V604s herunter. Camille Bauer SINEAX V604s 19 Seiten. Universal signal converter
Auch für Camille Bauer SINEAX V604s: Sicherheitshinweise (13 seiten)

Seite drucken
Address
Description
Data type #
40547
TSET
REAL
40549
SETTING
UINT16
40550
MATRIX
UINT8
40551
LIMITA
UINT8
14
Default
Description
1.0
Settling time (99%) [s] (1 ... 30)
Automatic parameter correction
00h
Settings
Bit
Description
0
Recognition of the type of connection (2L, 3L, 4L) after reset
1
Input 1: Breakage monitoring activated
2
Input 2: Breakage monitoring activated
3
Input 1: Short circuit monitoring activated
4
Input 2: Short circuit monitoring activated
Linking of inputs with outputs
0
01h
Output 1:
00h:
Not used
01h:
Input 1
02h:
Input 2
03h:
Input 1 + 2
04h:
Input 1 – 2
05h:
Input 2 – 1
06h:
Input 1 * 2
07h:
Minimum value (Input 1,2)
08h:
Maximum value (Input 1,2)
09h:
Mean value (Input 1,2)
81h:
Sensor redundancy: Input 1 normally
82h:
Sensor redundancy: Input 2 normally
87h:
Sensor redundancy: Minimum value (Input 1,2)
88h:
Sensor redundancy: Maximum value (Input 1,2)
89h:
Sensor redundancy: Mean value (Input 1,2)
- Only measured variables of the same unit may be linked.
- Product formation: Only possible for combinations V*mV, V*mA, mA*mA, mV*mA and mV*mV.
Sensor redundancy
- Measured variable in case of a fault:
INPUTx which does not show a fault
- Limitations:
- The same measuring range for both inputs
- The same scaling factors (always 1.0)
- No output value in case of a fault
- Temperature measurement
- Breakage or short circuit monitoring active
1
00h
Output 2 (same as Output 1)
at 2xmA:
02h
Setting of limit values
0
0
Measured variable for Limit value 1
Bit
Description
0-4
Limit value
6
Absolute value of measured variable for the limit value
7
1: Gradient dx/dt
Note: Drift monitoring is realised by difference calculation.
Only measured variables of the same unit may be linked.
1
0
Measure variable for Limit value 2 (same as Limit value 1)
Operating instructions V604s Be
2
0: Not used
1: Input 1 (INPUT1)
2: Input 2 (INPUT2)
3: Measured variable Output 1 (MEAS1)
4: Measured variable Output 2 (MEAS2)
5: Input 1 – Input 2
6: Input 2 – Input 1
Camille Bauer