American Standard Right Height Elongated Toilet Triumph Cadet 3 Instrucciones de instalación Cuidado y mantenimiento - Página 2

Navegue en línea o descargue pdf Instrucciones de instalación Cuidado y mantenimiento para Aseos American Standard Right Height Elongated Toilet Triumph Cadet 3. American Standard Right Height Elongated Toilet Triumph Cadet 3 13 páginas. 2-piece round front, elongated, right height toilets
También para American Standard Right Height Elongated Toilet Triumph Cadet 3: Especificaciones (1 páginas), Hoja de especificaciones (1 páginas), Hoja de especificaciones (1 páginas), Hoja de especificaciones (1 páginas), Hoja de especificaciones (1 páginas), Hoja de especificaciones (1 páginas), Instrucciones de instalación (4 páginas), Instrucciones de instalación Cuidado y mantenimiento (4 páginas), Instrucciones de instalación Cuidado y mantenimiento (4 páginas), Manual del usuario (8 páginas)

American Standard Right Height Elongated Toilet Triumph Cadet 3 Instrucciones de instalación Cuidado y mantenimiento

Before You Start:

Turn Off Water Supply
Recommended fitting type for
back-to-back installations.
1
4
Apply weight evenly. Do not move after
placement. Water tight seal may break.

If Removing An Existing Toilet

Flush to remove
water from tank;
sponge remaining
water from
bowl before
removing toilet.

BACK-TO-BACK INSTALLATION

Depending upon your plumbing and venting conditions, the flow from the toilet in a back-to-back
installation may create a vacuum on the system and draw water from the opposing bowl. The
National Standards Plumbing Code prohibits the use of a cross fitting for drainage as throw over
is possible. The code does approve a directional "Y" style fitting with proper venting to direct the
water downward and away from the other toilet.
2
Press firmly.
5
Hand Tighten Only.
!
Do Not Overtighten.
- 2 -
Clean Flange
Caution: If leaving floor flange
!
open for more than 1-2 hours,
cover flange to prevent escaping
sewer gases.
3
TIP: Place 2 pieces of masking
tape on floor (as shown) to help
with alignment in step 4.
6
Tank-to-Bowl Gasket
Place the tank gasket over the tank nut
ensuring there are not gaps between the
gasket and the chinaware.
7301555-100 Rev. 4 2/22