Bosch Ascenta SHE5AM02UC Instrucciones de reparación - Página 34

Navegue en línea o descargue pdf Instrucciones de reparación para Lavavajillas Bosch Ascenta SHE5AM02UC. Bosch Ascenta SHE5AM02UC 50 páginas. Quick reference instructions
También para Bosch Ascenta SHE5AM02UC: Manual de instrucciones de instalación (21 páginas), Manual de energía (2 páginas), Comenzar (2 páginas), Instrucciones de reparación (27 páginas)

3. Remove hose clamp to separate pump from adapter

(below left).

4. Disconnect support strap (below center).

5. To remove pump, slide pump off sump at seal ring (below

right). The seal ring can't be field removed from the heat

pump.

6. Disconnect the two (2) pump wire harnesses (below left).

To remove the small connector for the sensor harness with

black wires, unlatch it from it's terminal (below center).

7. If necessary, remove the adapter by removing four (4)

screws (below right).

TIP: The replacement heat pump comes with motor, pump, seal

ring and hose clamp.

NOTE: The motor can't be separated from the pump and the

seal ring can't be field installed.

702_58300000130262_ara_en_c

5.13

Float (safety system)

Tools needed:

T20 Torx, #2 Phillips & small flat blade

screwdrivers.

The float is best accessed from the bottom of the dishwasher by

flipping it upside-down or on it's back. Several plastic pieces

snap into place and must be carefully removed in sequence.

1. Remove toe kick – section 5.1.4.1.

2. Flip dishwasher for access – section 5.1.6.1.

3. Unscrew one housing screw (below left) and push one

cover tab (below right) to remove cover from float

assembly.

4. Float lever has tabs which lock onto the knob of the push

rod. Carefully push the push rod knob away from the lever

(below left).

5. Remove the float housing screw and remove the float

housing with lever (below center).

6. Remove the wire harness (below right).

Page 34 of 50