Bosch Ascenta SHE5AM02UC 수리 지침 - 페이지 34
{카테고리_이름} Bosch Ascenta SHE5AM02UC에 대한 수리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Bosch Ascenta SHE5AM02UC 50 페이지. Quick reference instructions
Bosch Ascenta SHE5AM02UC에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (21 페이지), 에너지 매뉴얼 (2 페이지), 시작하기 (2 페이지), 수리 지침 (27 페이지)
페이지 인쇄
3. Remove hose clamp to separate pump from adapter
(below left).
4. Disconnect support strap (below center).
5. To remove pump, slide pump off sump at seal ring (below
right). The seal ring can't be field removed from the heat
pump.
6. Disconnect the two (2) pump wire harnesses (below left).
To remove the small connector for the sensor harness with
black wires, unlatch it from it's terminal (below center).
7. If necessary, remove the adapter by removing four (4)
screws (below right).
TIP: The replacement heat pump comes with motor, pump, seal
ring and hose clamp.
NOTE: The motor can't be separated from the pump and the
seal ring can't be field installed.
702_58300000130262_ara_en_c
5.13
Float (safety system)
Tools needed:
T20 Torx, #2 Phillips & small flat blade
screwdrivers.
The float is best accessed from the bottom of the dishwasher by
flipping it upside-down or on it's back. Several plastic pieces
snap into place and must be carefully removed in sequence.
1. Remove toe kick – section 5.1.4.1.
2. Flip dishwasher for access – section 5.1.6.1.
3. Unscrew one housing screw (below left) and push one
cover tab (below right) to remove cover from float
assembly.
4. Float lever has tabs which lock onto the knob of the push
rod. Carefully push the push rod knob away from the lever
(below left).
5. Remove the float housing screw and remove the float
housing with lever (below center).
6. Remove the wire harness (below right).
Page 34 of 50