Draper FlexShade NEXD Instrucciones de instalación y funcionamiento - Página 3

Navegue en línea o descargue pdf Instrucciones de instalación y funcionamiento para Mobiliario interior Draper FlexShade NEXD. Draper FlexShade NEXD 10 páginas. Clutch-operated small and large hardware
También para Draper FlexShade NEXD: Instrucciones de instalación y funcionamiento (6 páginas), Instrucciones de instalación y funcionamiento (8 páginas), Manual de instrucciones (8 páginas), Instrucciones de instalación y funcionamiento (8 páginas), Manual de instrucciones (12 páginas)

Bottom-Up FlexShade

Small and Large Hardware

Please Note: If installing Pocket Headbox or Surface Headbox, please install headbox FIRST

Section 1 - Endcap Covers

Caution: Before mounting shades, verify measurements on label provided with shade, and ensure unit is installed at correct width.

Please Note: Installer is responsible for selecting mounting hardware appropriate for site conditions.

Snap endcap covers into place

Figure 1

Caution: Before mounting shades, verify measurements on label provided with shade, and ensure unit is installed at correct width.

Please Note: Installer is responsible for selecting mounting hardware appropriate for site conditions.

1. Mark wall, ceiling, or jamb for placement of endcaps.

2. Drill small starter hole

(if necessary)

Figure 2

NEXD,

(Fig. 1)

in mounting surface.

3. Attach idler and operator endcap covers to endcaps.

4. Mount endcaps using appropriate fasteners for surface.

page 3 of 10

(Section 12)

PLEASE NOTE:

If endcap covers are

included in order,

drill through endcap

cover and secure

with endcap.

Endcap requires

a minimum of

two fasteners.

It is not necessary

to utilize all four

corners.