Draper FlexShade NEXD Instrukcje instalacji i obsługi - Strona 3
Przeglądaj online lub pobierz pdf Instrukcje instalacji i obsługi dla Wyposażenie wnętrz Draper FlexShade NEXD. Draper FlexShade NEXD 10 stron. Clutch-operated small and large hardware
Również dla Draper FlexShade NEXD: Instrukcja instalacji i obsługi (6 strony), Instrukcje instalacji i obsługi (8 strony), Instrukcja obsługi (8 strony), Instrukcje instalacji i obsługi (8 strony), Instrukcja obsługi (12 strony)
Drukuj stronę
Bottom-Up FlexShade
Small and Large Hardware
Please Note: If installing Pocket Headbox or Surface Headbox, please install headbox FIRST
Section 1 - Endcap Covers
Caution: Before mounting shades, verify measurements on label provided with shade, and ensure unit is installed at correct width.
Please Note: Installer is responsible for selecting mounting hardware appropriate for site conditions.
Snap endcap covers into place
Figure 1
Section 2 - Mounting Endcaps
Caution: Before mounting shades, verify measurements on label provided with shade, and ensure unit is installed at correct width.
Please Note: Installer is responsible for selecting mounting hardware appropriate for site conditions.
1. Mark wall, ceiling, or jamb for placement of endcaps.
2. Drill small starter hole
(if necessary)
Figure 2
NEXD,
®
.
(Fig. 1)
in mounting surface.
3. Attach idler and operator endcap covers to endcaps.
4. Mount endcaps using appropriate fasteners for surface.
page 3 of 10
.
(Section 12)
PLEASE NOTE:
If endcap covers are
included in order,
drill through endcap
cover and secure
with endcap.
Endcap requires
a minimum of
two fasteners.
It is not necessary
to utilize all four
corners.