Dremel 3D20 Idea Builder Manual de inicio rápido

Navegue en línea o descargue pdf Manual de inicio rápido para Impresoras 3D Dremel 3D20 Idea Builder. Dremel 3D20 Idea Builder 2 páginas. Unclogging
También para Dremel 3D20 Idea Builder: Manual de inicio rápido (8 páginas), Manual de inicio rápido (2 páginas), Manual de inicio rápido (8 páginas), Manual de inicio rápido (4 páginas), Manual de inicio rápido (4 páginas), Manual de solución de problemas (2 páginas), Manual de inicio rápido (2 páginas), Manual de inicio rápido (2 páginas), Manual de inicio rápido (2 páginas)

Read the Dremel 3D20 manual and

these instructions. Failure to comply

with the warnings and instructions may result in fire,

equipment damage, property damage, or personal

Always unplug Dremel 3D20 from its power before per-

forming any service procedures. Failure to do so may

re-sult in personal injury and equipment damage.

Use only Dremel approved materials and components.

Use of object materials, or 3D objects other than Dremel

approved

object

materials

components may void warranty.

Repairs on the Dremel 3D20 may require the use of special

tools (pulling devices and bearing press). Authorized repair

centers have trained repair technicians and equipment

necessary to perform these repairs.

Do not touch the extruder tip or heated build platform during Dremel 3D20 operation or until it

has cooled down to at least 60oC (140oF). Contact with the extruder tip or build platform during or

after operation before tip and build platform has cooled may result in personal injury.

Please click here for Video Tutorial

Tools Required:

• Scissors

• 2,5 mm Allen key

• Needle Nose Pliers

Step 1: Remove the top cover

Unclogging the 3D20

injury.

and

genuine

Dremel

SERVICE INSTRUCTIONS

For the location of the repair center near you, look on

our web site at www.Dremel3D.com and follow the link

for 'Support'.

Step 2: Unload filament from the extruder.

Step 3: Power off then unplug the power

cord from the Dremel 3D Idea Builder.