Belden FX FUSION SC CONNECTOR Manual de instalación - Página 3
Navegue en línea o descargue pdf Manual de instalación para Cables y conectores Belden FX FUSION SC CONNECTOR. Belden FX FUSION SC CONNECTOR 8 páginas. 900μm tight buffer/250μm
También para Belden FX FUSION SC CONNECTOR: Manual de instalación (8 páginas)
Imprimir página
Fusion Splicer setup:
1.
Follow the manufacturer's
instructions:
A. Perform calibration and arc
check.
B. Select the appropriate splicing
mode based on fiber type
(SM or MM).
C. If applicable remove the left
fiber holder.
D. Set the heating mode by
referring to the heat setting
table on the first page.
2.
Just before use, open the sealed
bag of the FX Fusion Splice-On SC
Connector Kit.
FX FUSION SC CONNECTOR
2 mm - INSTALLATION GUIDE
3.
Insert the 2 mm pigtail cable into
the clamshell.
4.
Open the clamshell carefully by
lifting the top cover and sliding
your finger toward both sides (right
and left).
Clamshell open:
PX106501-EN REV C
Top cover
Page 3 of 8