Belden FX FUSION SC CONNECTOR Kurulum Kılavuzu - Sayfa 3
Kablolar ve konektörler Belden FX FUSION SC CONNECTOR için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Belden FX FUSION SC CONNECTOR 8 sayfaları. 900μm tight buffer/250μm
Ayrıca Belden FX FUSION SC CONNECTOR için: Kurulum Kılavuzu (8 sayfalar)
Sayfayı Yazdır
Fusion Splicer setup:
1.
Follow the manufacturer's
instructions:
A. Perform calibration and arc
check.
B. Select the appropriate splicing
mode based on fiber type
(SM or MM).
C. If applicable remove the left
fiber holder.
D. Set the heating mode by
referring to the heat setting
table on the first page.
2.
Just before use, open the sealed
bag of the FX Fusion Splice-On SC
Connector Kit.
FX FUSION SC CONNECTOR
2 mm - INSTALLATION GUIDE
3.
Insert the 2 mm pigtail cable into
the clamshell.
4.
Open the clamshell carefully by
lifting the top cover and sliding
your finger toward both sides (right
and left).
Clamshell open:
PX106501-EN REV C
Top cover
Page 3 of 8